Hi all, Have a little issue I hope someone can help me with. I recently got a pair of Panasonic PT-AR100U projectors. Issue is that I can't find or figure out how to reset the projector to factory defaults. There are a bunch of the settings grayed out with no clear way access them. The original install was ceiling front which means inverted and reversed. Any Ideas? Thanks in Advance!

Yah, I have spent more than a fair amount of time going thru the manual for the unit I pulled down from the site. I also have been thru every menu on the projector as well but to no avail. Seems rather odd that there is no way to default the projector in the manual. I will dig at it again tomorrow and see if there is anything I missed. I will also throw a signal into the HDMI port as well just in case. I know that for some of their other projectors there are a pair of button presses that are used to reset the unit but they didn't work on this one. I also perused the serial interface table as well to see if there was a command but nothing was found... Sigh. What a PITA. At least I didn't have to pay for the unit so.