I have an LP 350 by InFocus and the bulb wont work. When I power on the projector a blinking green LED comes on and for about the first 15 seconds the projector makes a reving sound. The bulb never comes on and then the green LED changes from blinking green to a red/amber color. I have tried to reset the bulb hour counter, and a few other tricks. I appreciate any help, right now the projector is opened up so I could inspect the circuit board, found nothing obviously wrong with it.
I have the same projector and my lamp just blew out. Did you get the new firmware on yours? Could you tell me how you did it and sell me the adapter you made, or do I need to do something else to get a new lamp for it and make it work.
so here is the deal
for the first 30 minutes it is on there is no problem
after that variously it will slightly distort
at top corners for fractions of a second at a time
it also will show 2 very faint horizontal lines
and the color kinda looks like a psychedelic wash
all of these symptoms are very minor
but it is better to figure it out before it gets worse
i opened the unit and cleaned the fans
which seemed to help a little
i kinda think it may be heat induced
because he first 30 minutes its fine
i also have no clue how many hours the bulb has on it
the unit never seems to keep up with that
any help is appreciated
thanks in advance
http://www.youtube.com/v/qS6RRGtN1r8
Hello, I've got an Infocus LP350. I've had it since 2001 and it was brand new and still has lots of life in it. My first lamp bursted and I've got a spare lamp that I've just installed.
Unfortunately my firmware is older and the newest one helps preserve the lamp life. I've looked long and hard and nobody seems to have the required Cablewizard to RS232 adaptor in stock. I've purchased a Cablewizard 2 only to discover it has a proprietary 5 Pin Mini Din (PC Serial) connector and Infocus does not make that serial connector any longer.
All the service centers want to charge me $300 - $400 to service it, nobody will provide me a pinout as I can create my own adaptor...
If anyone has this connector, I wouldn't mind paying for it even though it's going to be a one-time one-use deal for me. Please let me know.
If anyone knows the 5 Pin Mini-Din to DB9 pinout or has that serial cable, I would purchase that. Either one would work, thanks in advance!
Hello,
I noticed that from time to time on my projector screen, there is a vertical line with a width of approx. 3-5 pixels that have disappearing text. When I view images, that same area appears shifted up slightly. Sometimes the image is fine...
What can the problem be...
Thanks
Infocus LP-350 lamp wont work
