Hi, I am new to the forum and there is a wealth of info here. I purchased a used Sharp xg-p10xu to use for a church projector. I am looking for a spare bulb to be prepared when the current one blows. I found this one on ebay, will it work? http://cgi.ebay.com/PHILIPS-UHP-200W-WATT-1-0-PROJECTOR-BULB-BRAND-NEW_W0QQitemZ220341784251QQihZ012QQcategoryZ15251QQssPageNameZWDVWQQrdZ1QQcmdZViewItem It says it will fit the "caddie" of the xg, and it is a round 200W, UHP It is significantly cheaper than the other bulbs listed on ebay for the xg, but looks like the same thing. Any experiences would be appreciated. Thanks Brad

...they decided not to communicate. When I connect a G4 (requiring a Mac/VGA adapter)I get an amber over scanned image temporarily and then nothing. I'm using an SP Controls panel (which is basically just button-mapping). My pcs have no problem. I checked the g4's refresh (60HZ) and resolution (1024) against Sharp's faq and everything seems ok. Has anybody run into this before? I believe this is a recent issue and the instructor used his G4 with this Sharp before, but I can't be 100% sure. I tried a new adapter just in case and had the same problem. Thanks, avdude

I managed to misplace the 5 screws that seat the lamp housing to the projector. Can I use any appropriate sized screw or does it need to be a certain type? If it does need to be a certain type, does anybody have any suggestions regarding a vendor? Thanks.